Category Archives: Beads

Bead Necklace

Fabric covered beaded necklaces have been around for a long time.  I remember making one in Girl Scouts when I was a kid.  For this reason, I wasn’t really big on the idea of actually wearing one as an adult.  Then I saw this adorable bracelet from Hannah Handmade!  I considered making a bracelet, but I really like statement necklaces.  I also found this tutorial for a fabric covered beaded bracelet by Goody-Goody Handmade in my awesome sewing calendar.  I decided to combine my favorite parts of both bracelets to come up with my own design!  The best part about this project was that I had everything I needed on hand and it was easy enough that I could wear the necklace the next day!

Materials needed:

  • Beaded costume jewelry (the beads are easier to work with if they are already attached in a string – mine are about 3/4″ in diameter)
  • Fabric
  • Embroidery Floss
  • 30″ of ribbon
  • Two 3″ segments of ribbon to cover the fabric/ribbon connection
  • Sewing Machine
  • Scissors
  • Hot glue gun (or another type of fabric glue, if you prefer)
  • Fray check (optional)

Instructions:

  1. Measure your fabric against your beads.  The fabric should be wide enough to surround your beads plus 1/2″-3/4″ for wiggle room and the seam.  The fabric should be long enough to cover your length of beads plus several inches.  My bead string is about 12″ long and my fabric was about 20″ long.  I had some fabric leftover, but I wanted to make sure I had enough.
  2. Once you have cut out your fabric strip, fold it in half lengthwise with right sides facing in.  Sew a 1/4″ seam down the long side of the fabric.  Turn this tube inside out.
  3. Feed the bead string through one end of the fabric tube.
  4. Use the embroidery floss to tie a knot in between one set of beads.  Wrap the floss around the knot several times and then tie a second knot to secure it.  I started in the middle of the bead string and the middle of the fabric to make sure I had equal amounts of fabric at either end.
  5. Once you have finished tie all the beads in place, trim the excess fabric at each end down to about 1″.
  6. Cut the ribbon so that you have one piece that is about 20″ long and another that is about 10″ long.  Use glue to attach one end of each piece of ribbon to one end of the fabric.
  7. Glue the ends of the 3″ pieces of ribbon down to prevent fraying.  If you are using hot glue, use as little as possible for this step as the glue does not allow for much flexibility.  I was in a hurry to finish this project for the next day, so I did not want to wait for another type of glue to dry.
  8. Wrap the ribbon segments around the messy ends of fabric and ribbon and use glue to secure.
  9. Tie a bow with the two lengths of ribbon close to one end of the necklace.  Trim any excess ribbon.  Be sure to cut the ends of the ribbon at an angle to prevent fraying.  Fray check can be applied at this point, but I didn’t have any on hand.
  10. The finished necklace should be big enough to slip over your head.  Therefore, if you want to secure the bow with glue or thread, feel free!
  11. Wear the necklace and admire your handiwork!

Linking up here:

PhotobucketAnything RelatedPhotobucket

3 Comments

Filed under Babies/Kids, Beads, Clothing, Fabric