Tag Archives: ruffle

Spring Wreath

I LOVE the color yellow!  It is just so bright an cheery!  While rummaging through the scrap bin at Hobby Lobby, I found a whole bunch of this yellow fabric for about $3!  Its a pretty basic print, so I wasn’t sure what to do with it, but I couldn’t pass up the happy color!  Then I found this gorgeous wreath at Beautiful Nest and it occurred to me that I never make wreaths.  Like, seriously, I think I’ve only ever made one wreath before in my life.  I thought the yellow would be perfect for bringing a little spring into my life with this wreath!  Since I live in an apartment right now and don’t really trust my neighbors to leave it alone, this wreath is going to decorate the inside of my door!  Then I get to enjoy it all the time!

Notes about the project:  I left the edges of the fabric raggedy to add a little bit more of a homemade touch.  Also, my goal was to use on-hand supplies, so my fabric and wire were a little too flimsy to support themselves.  I found a cardboard frame was necessary, but it might not be necessary for your wreath.

Materials needed:

  • 5-1/2″ strip of bottom fabric (I used 3 strips of each fabric about 45″ long – from selvage to selvage)
  • 2-1/2″ strip of middle fabric
  • 1″ strip of top fabric
  • Extra fabric or ribbon for the hanger and embellishments
  • Wire (about 30″)
  • 12″ cardboard circle with 5″ circle cut out of middle (optional)
  • Small cardboard rectangle (optional)
  • Scissors
  • Some sort of hole punching device (I used a seam ripper)
  • Glue (I used hot glue – I’m so impatient!)


  1. Cut all of your strips of fabric.  Perfect measurements aren’t necessary.  I like things to look slightly amiss sometimes.  It gives them character!  I probably should have ironed my fabric, but its just character!  My Marine Corps husband would have a huge problem with this.
  2. Lay the strips out flat.  Place the smaller strips on top of each other and make sure the right sides of all fabric are facing out.
  3. Pierce a hole through all three layers of fabric about every 1-2″ along the length of the fabric.  Make sure these holes are in the center of fabric.
  4. Thread the wire in and out of the holes until all the fabric is on the wire.  When you reach the end of one strip, just start on with the next one!  The holes in the above photo with the wire are about 3 inches apart, but I decided I wanted them closer – just in case you are worried that your wire doesn’t look like mine.
  5. Once all the fabric is on the wire, spread the fabric out and twist the ends of the wire together to create a loop.
  6. If your wreath is flimsy and you need a cardboard base, continue with this step.  If not, skip to the next step.  Carefully flip the wreath over so the backside is showing.  Arrange the folds in a pleasing manner.  Apply glue to the cardboard base and slap it onto the back of your wreath.
  7. Loop the hanger ribbon (or fabric…or whatever else you might want to use) and glue it to the back of the wreath.  You may choose to glue a small cardboard piece down on top of the ribbon ends to secure them.
  8. When the wreath is dry, flip it back over to the front side and get to decorating!  I used a fabric bow (again leaving the edges raw), but you could use flowers, Easter eggs, bird stuff…whatever blows your hair back! (Notice my lack of creativity in the embellishing department…this would be my novice wreath making skills coming out)
  9. Enjoy!

Linking up here:

Catch a Glimpse ButtonPhotobucket



Filed under Cardboard, Decorations, Fabric